Posts tagged op-amp
1- What we call this opamp configuration? 2- What's the advantage and the disadvantage of this circuit? 3- And what's the purpose of the L2 in the feedback? I have changed gradually the value of...
I am planning to use the LM318 operational amplifier to generate a PWM signal and I need to know how to calculate the rise/fall time. LM318/LM218/LM118 datasheet -The slew rate is 70 V/µs maximum...
I am designing a DC/DC converter in the control loop of which a transconductance amplifier (OTA) is used. This part of circuit looks like this: To determine the needed characteristics, I am usin...
In noise analysis of operational amplifiers, the following is considered: Noise generated by the external components (resistors in feedback network etc.) Noise generated by the operational ampl...
Inside a op-amp after the stage where the differential signal is converted to single ended , there is further amplification of the DC signal.For AC signals there is a capacitor parallel to the tran...
In the image below is an opamp buffer with +/- 15v rails connected to a 3.3v ADC. The input to the opamp is limited to 0-3v. There is no protection circuitry for the ADC. Is the risk of the opam...
More about the circuit The circuit is sensing (low side sensing for many reasons) current used to power up the lights with 28V(part of the schematics not shown here -> relay with LC filter ...
Hi, I built a constant current load following the circuit from https://www.instructables.com/id/DIY-Constant-current-load/ But my op amp gets destroyed after a few minutes. The transistor or the op...
This application note from Linear Technology discusses oscillations in opamp circuits and some compensation schemes. One method discussed for reducing phase shifts in the loop gain due to the RC ne...
I've built a non-inverting op-amp amplifier with a gain of 101 using this circuit: - My input is 10 mV DC and I expected to measure 1.01 volts at the output but I measure 0.81 volts. What has happ...