Review Suggested Edit

You can't approve or reject suggested edits because you haven't yet earned the Edit Posts ability.

Burned Source Driver - Noise Spikes from Relay Coil

~~I am trying to figure out what is causing an Allegro A2982 source driver to burn up.~~
The source driver (A2982) is connected to the coil of a Panasonic TXS2-9V relay. The source driver and coil are connected by about 3 feet of wire. The source driver is on the high side and the coil is on the low side.
The rail of the source driver (Vs) is 9 V. The source driver output is ~7.4 V. The peak voltage of the spike, measured across the inductor, is ~13.2 V. Note: I am using a differential probe to measure the voltage across the coil.
~~![Image_alt_text](https://electrical.codidact.com/uploads/vqtgn1dxdkpk6uc4alv7wmd852lm)~~
Is it a valid concern that:
1. This voltage spike is causing damage to the source driver?
2. The 9V supply may see the voltage spike and cause damage?
3. The Vbe reverse breakdown voltage of the darlington-pair may be exceeded and cause damage?
If the spike is causing damage, is there a way to reduce or mitigate the spike?

I am trying to figure out what is causing an [Allegro A2982 source driver](https://www.allegromicro.com/~/media/Files/Datasheets/A2981-2-Datasheet.ashx) to burn up.
The source driver (A2982) is connected to the coil of a Panasonic TXS2-9V relay. The source driver and coil are connected by about 3 feet of wire. The source driver is on the high side and the coil is on the low side.
The rail of the source driver (Vs) is 9 V. The source driver output is ~7.4 V. The peak voltage of the spike, measured across the inductor, is ~13.2 V. Note: I am using a differential probe to measure the voltage across the coil.
![Waveform](https://electrical.codidact.com/uploads/vqtgn1dxdkpk6uc4alv7wmd852lm)
Is it a valid concern that:
1. This voltage spike is causing damage to the source driver?
2. The 9V supply may see the voltage spike and cause damage?
3. The Vbe reverse breakdown voltage of the darlington-pair may be exceeded and cause damage?
If the spike is causing damage, is there a way to reduce or mitigate the spike?

relay source-driver