Post History
Yes, this is safe, but you do have to consider the layout carefully. You have to make sure that nothing conductive gets between the pads of each resistor. For this high voltage safety purpose, you...
Answer
#2: Post edited
by
Olin Lathrop
·
2020-07-24T22:24:48Z (over 4 years ago)
- Yes, this is safe, but you do have to consider the layout carefully.
- You have to make sure that nothing conductive gets between the pads of each resistor. For this high voltage safety purpose, you can't consider the solder mask as a reliable insulator. If a trace goes between the pads of a resistor on the same layer, then it subtracts from the clearance distance.
You also have to make sure the end to end spacing is met. For example, don't arrange the resistors in a ring so that the beginning and end of the ring are close together. If you string out the resistors in a line and make sure nothing else is near, then it is valid to add the maximum voltage ratings of the resistors to get that of the overall resistor.
- Yes, this is safe, but you do have to consider the layout carefully.
- You have to make sure that nothing conductive gets between the pads of each resistor. For this high voltage safety purpose, you can't consider the solder mask as a reliable insulator. If a trace goes between the pads of a resistor on the same layer, then it subtracts from the clearance distance.
- You also have to make sure the end to end spacing is met. For example, don't arrange the resistors in a ring so that the beginning and end of the ring are close together. If you string out the resistors in a line and make sure nothing else is near, then it is valid to add the maximum voltage ratings of the resistors to get that of the overall resistor.
- Consider your pad dimensions too. Make sure there isn't too much extra pad underneath each resistor so that the clearance distance becomes too small for the full voltage the resistor can take.
#1: Initial revision
by
Olin Lathrop
·
2020-07-24T22:21:51Z (over 4 years ago)
Yes, this is safe, but you do have to consider the layout carefully. You have to make sure that nothing conductive gets between the pads of each resistor. For this high voltage safety purpose, you can't consider the solder mask as a reliable insulator. If a trace goes between the pads of a resistor on the same layer, then it subtracts from the clearance distance. You also have to make sure the end to end spacing is met. For example, don't arrange the resistors in a ring so that the beginning and end of the ring are close together. If you string out the resistors in a line and make sure nothing else is near, then it is valid to add the maximum voltage ratings of the resistors to get that of the overall resistor.