Posts by ReliablePotion
There is a plan to do PDN decoupling simulation for the KSZ9897RTXI power rails. It has various power supply like 1.8V, 2.5V& 1.2V. While doing the simulation, what is the maximum frequency ran...
We perform a test on this device where the regulator input power is enabled with an 8A load connected to the output, while the device itself remains disabled. We then drive the EN pin high to enabl...
We’ve been working with the this boost regulator and set it up according to the attached schematic. To minimize power consumption, the approach was to enable the boost once every 31.25 ms: we pull ...
I am using this MPU SOM Module and this NAND Flash device for storing the boot image. I will also use a 4-bit SD card interface with the MPU for data logging. I’m reviewing the MPU datasheet (link...
