Posts by TonyStewart
The two-terminal symbol for the attenuator comes from 3 pin potentiometer (pot.) referenced to 0V = "GND" The summing amplifier is always inverting and gives you 3 options for gain which means i...
I agree with Olin that unknown contact area is the biggest variable. I think the scientific way is to test and verify each contact using a 4 pin kelvin bridge. The sum of 2 pins carrying constant...
The 70.9/40.8 A rating for L.R. is rated only for ; Locked rotor time 19s (cold) 11s (hot) I doubt this meets your requirements unless you modify from a forced air cooling motor to a pumped liqu...
As of the early 2020s, common technology nodes for SSI (Small-Scale Integration) and MSI (Medium-Scale Integration) ICs include nodes such as 180nm, 130nm, 90nm, 65nm, 45nm, and 28nm. Each technolo...
If you choose suitable ultrabright LEDs , there is no need to use 40 mA. I have over 10 thousand LEDs all over 16,000 mcd at 20 mA which is painfully bright for close indicator but works well 100 ...
Remember that RMS measurements assume at least 1 cycle or in your case 100 ms or 10 Hz. So the Ripple Current/rms vs Temp rise is always valid for any duty cycle. This means in theory you can rai...
Will shorting a lithium ion battery cause an explosion? Chain Reaction: The release of flammable gases can lead to a chain reaction, where the heat generated by the short circuit causes even m...
The other answers are excellent justification to the the industry standards imposed on CMOS logic. The historical migration to smaller lithography CMOS led to lower Cds values which led to faster ...
The spec 79V 0.5 ohm 5ms = 62.41 Joules . The TVS must be rated for a low temp. rise at this energy dump or higher. MOV's are limited by the number of discharges as the oxide wears out, but may be...
Microwave Materials, Spectrum then EMI effects on SNR of WiFi, BT. There are a lot of measurable parameters in microwave dielectrics which affect; Dielectric Constant , Dk between conductors an...
This IC is not well suited for the task. MPPT (Maximum Power Point Tracking) relies on matching impedance according to the maximum power transfer theorem. However, in the case of a photovoltaic ar...
For R loads I is in phase with V. For L loads , V lags I up to 90 deg. For C loads, I lags V up to 90 deg. The trigonometric tangent angle is the ratio of impedance: Real to reactive. Your le...
The problem with cable emissions from HS data and SMPS noise is very common even with UTP and ribbon cable with adjacent grounds on differential signals. I have seen this frequently on HDD testing...
If you mean electret microphone, no damage to JFET buffer. Microphone input won't damage a headset with it's current limited pullup resistor for electret Mics.
This LC circuit depends on several criteria for stable linear oscillation; 180 deg phase shift ( with 3rd order LC network) plus 180 degree inversion to achieve the oscillation criteria of 0 or ...
The RSSI detector in the receiver is the best field tool. In Windows I had a tool (Wifi Radar?) that read the Broadcom IC RSSI and displayed a time plot of the results as I changed laptop orientati...
In my 15 yrs of intense deadline R&D for new state-of-the-art design in my 45yrs experience, estimation of time is inversely proportional to the number of mini failures from bad assumptions fro...
- ← Previous
- 1
- 2
- Next →
