Activity for kellogsā
Type | On... | Excerpt | Status | Date |
---|---|---|---|---|
Question | — |
derating MLCC ripple current for transient current spikes This graph - MLCC temperature rise vs ripple current RMS & frequency Imagealttext If I had a 10 us current spike every 100 000 us (akin to a half-sine wave and then the rest of 9999 sine waves missing), how much higher can i go in current ripple RMS value for the 20 deg. C max temp rise ? (more) |
— | 8 months ago |
Question | — |
Power switches and automotive load dump, unclamped Power switches used in automotive are usually rated to withstand clamped load dump events, of the 35 - 40 V peak variety. AFAICT there are two main clamping mechanisms - first one for the logic part and second one for the MOSFET DS channel within. These power switches will generally (re)open the DS c... (more) |
— | 9 months ago |
Question | — |
Two way circuit breaking capability for ideal diode controllers I would like to save some costs with ideal diode controllers. Basic requirement is for the diode controller to block overcurrents (short circuits) in both directions. The MAX16141A IC can do it and the datasheet openly discusses it, i.e with two back to back MOSFETs and a sense resistor Thie ... (more) |
— | 9 months ago |
Question | — |
Floating circuitry and diodes In both cases, is the "X" point floating when there is no 12V applied ? (more) |
— | 10 months ago |
Question | — |
Variant of a Mosfet's Gate-Source protection Let's say a 100V voltage spike arrives at +12V and the TVS diode clamps it to 25V. Q2 may or may not be activated. Will this circuit ensure a Vgs lower than 25V for the mosfet Q1 ? Any catch to it ? Imagealttext Thanks (more) |
— | 11 months ago |
Question | — |
what should the output be for this use case of the CD4047 chip? Hello, I am trying to use a `CD4047` in monostable, positive-edge trigger mode: Image alt text Image alt text I am not skilled enough to make out what the output, i.e. pin 10, should be when pin 8, the input, is held at 0V (0.1V for some reason). Would expect it to be 0V, I am getting Vdd in... (more) |
— | 12 months ago |
Question | — |
MOSFET protection with TVS: at the source pin or at the drain pin In the auotmotive context, does it matter where the fat load-dump grade diode is placed in relation to the MOSFET so as to protect it from both fast positive transients and the longer load dump ? Thank you (more) |
— | 12 months ago |