Posts tagged semiconductor-diode
Subtag of semiconductor-device · 7 child tags
Power switches used in automotive are usually rated to withstand clamped load dump events, of the 35 - 40 V peak variety. AFAICT there are two main clamping mechanisms - first one for the logic par...
More about the circuit The circuit is sensing (low side sensing for many reasons) current used to power up the lights with 28V(part of the schematics not shown here -> relay with LC filter ...
Based on this paper on Wiki a diode can be described as a frequency mixer due to the exponential relationship between current and voltage.What I don't get from which point to which point do we meas...
Suppose we have this circuit which is supposed to be an unbalanced frequency mixer. But how does the diode generate a signal with new frequencies at the output?
I've seen a few different circuits (a) (b) (c) (d) described as "an O-ring circuit" or "an optimal O-ring circuit". What does the "O" and the "ring" refer to in such circuits? How do "O-ring circ...
If we a varactor and we want to control let's say the resonant frequency of the circuit ,in my schematic we must add R1 correct?Else we create a low resistance path for current to flow not through ...
Which are the parameters I should looking for when picking a flyback diode to be placed across a generic coil, such as a relay? That is: a coil with plain on/off functionality, for example a 24VDC ...
I've accidentally burnt my dimmer with a short. It is a common dimmer with a triac/diac/pot of the simplest configuration (the triac is a BTA16). After replacing the triac, this still does not work...
In both cases, is the "X" point floating when there is no 12V applied ?
I have been trying to model this oscillator I was wondering if we can somehow predict the frequency of the oscillations.For small currents inside a diode from the Shockley diode equation $$ e^{x...
The current through the tunnel diode is: where $I_{f}$ is the current from the Shockley diode equation and $I_{tunnel}$ is the tunnel current. Is there an expression for the tunnel current or i...
I am trying to understand tunnel diodes by experimenting with them. Research tells me they can have negative resistance, and can be used to build a high frequency oscillator. Tunnel diodes are su...
Simple thing that I realized I should know but do not -- when is an MOV preferable to a TVS diode (with some associated network to really make it work, in both cases)? Is it even something to routi...
Do common-source JFET amplifiers have an advantage over common-drain? The JFET would be in a low noise photodiode amplifier. The signal is 100us pulses with 10us raise times. Here are the schema...
Let's say a 100V voltage spike arrives at +12V and the TVS diode clamps it to 25V. Q2 may or may not be activated. Will this circuit ensure a V_gs lower than 25V for the mosfet Q1 ? Any catch to it...
I have a solar panel rated for 6V open-circuit and up to 150mA. I would like to connect this to an SPV1040 or similar buck-boost converter with MPPT functionality to be able to charge a 3.6V batter...
In the auotmotive context, does it matter where the fat load-dump grade diode is placed in relation to the MOSFET so as to protect it from both fast positive transients and the longer load dump ? ...
In the circuit below, I am applying a $3.3Vpp$, $63kHz$, 50% Duty Cycle, PWM input signal at the gate of the mosfet and I am expecting to see a similar waveform with different amplitude at the LED...
