Posts tagged circuit-analysis
I'm having trouble using the nodal equations to determine the base voltage Vb1 in the circuit below. I've attempted to write seven equations below, but not able to fit them in entirely. (12-Vx)...
I was analyzing the design a hazard warning light.The spec of the light turn on off is given below. The flashing-light frequency shall be 90+/-30 times per minute. May I know in this case the...
A taper pad is a resistive attenuator that maintains impedances on both ports and provides a specific amount of gain-loss ($A_{12}$): - I have derived formulas for each resistor (that I know to ...
If I connect a battery to an LC tank and then to an antenna and then on the other side at a distance x, I connect an antenna to another LC tank and this to a diode and this to an LED, Do a I have a...
In this circuit below the relay circuit part is acting as an inrush current limiter, but I can't understand how it works since the current is flowing in both conditions where the relay is open or c...
I am calculating the base current of transistor Q1. To simplify the circuit equations, I applied the Thévenin's theorem twice and converted V1, R1 and R2 into Vth and Rth, as shown in the image. ...
I am trying to analyse what is controlling the load current in the below Darlington configuration. Is it the base current of transistor Q3 which is controlling current through R14 / emitter curr...
In both cases, is the "X" point floating when there is no 12V applied ?